top of page
Search

OMGEXTRD F1 extruder upgrade FLSUN super racer sr installation and setup steps.

Updated: Mar 27, 2023


Set E-step value:365.

Note: The 2 spring screws at the bottom of the extruder should not be tightened too tightly, which will cause too much resistance to the rotation of the motor gear!

You can test the tightness by pulling it by hand.

Updating this firmware version:

SR Firmware V1.4

173 views1 comment

1 bình luận


777777tea
777777tea
27 thg 3, 2023

Set E-step value:365.

Note: The 2 spring screws at the bottom of the extruder should not be tightened too tightly, which will cause too much resistance to the rotation of the motor gear!

You can test the tightness by pulling it by hand.

Updating this firmware version:

https://flsun3d.com/pages/sr-firmware

SR Firmware V1.4

Thích
bottom of page