F22.jpg

OMGEXTRD F1
(1.75mm)

  • ENDER Long-distance extrusion

  • Upgrade example model: ENDER 3 V2

  • Net weight: 64g(no motor)

  • Double drive 1:3 Gear Ratio

  • E-steps:385 subdivision 16 step angle 1.8°

  • F1-set kit does not include stepper motor

PLEASE NOTE:

*When tightening the Bowden tube interface screws in the upper and lower holes of the aluminum alloy cover, do not use a wrench tool to forcefully tighten them, but tighten them by hand.

*Before tightening the screws, please remember to place the small ring-shaped metal washer first.

TOOL.jpg
F116.jpg

Notice:

​Long-distance 
STL print slicing software (CURA, etc.) Retraction setting:
Suggested value: Speed 30mm/s Retraction​ Distance: 7mm

  • A Install the filament Press bearing using a Cross screwdriver

  • B Put in the middle part (see the picture), Insert the Spring and Screw in the fixing nut (M6)

  • C Install the Teflon bowden, Blue bowden clip is used to fix the Teflon tube(4mm) not move.

f1111.jpg
F112.jpg
F113.jpg
F114.jpg
F115.jpg
F117.jpg
F118.jpg